Beard M4 by adamthwaites copyright 2010.


http://www.most-digital-creations.com/beard_michael_4.htm


All of this product's content was created by adamthwaites (Adam Thwaites)


Product Support: Admin@most-digital-creations.com



Files List:

ReadMeBeardM4.txt

(see the list below for all other included files)



Needed Files List:

Poser 5 or newer OR DAZ Studio (free or advanced)

NOTE: The beard will also work fine in Poser 4, but there are no .rsr thumbnail files included



Installation Instructions:

1. Extract the Zip folder to the folder where your Poser Runtime is located OR to your DAZ Studio content folder. If you are using one of the newest versions of Poser you should click the "Content" tab
inside Poser, then click "Install From Zip Archive" and finally navigate to the zip file for this product that you downloaded.

2. As an alternative you can extract the Zip folder to a different location and manually copy the folders and files to the correct location as listed below.



Exact folder names and locations:

..\Runtime\Geometries\BeardM4\
   Beard.obj

..\Runtime\libraries\Character\BeardM4\
   Beard.cr2
   Beard.png

..\Runtime\libraries\Pose\BeardM4\
   Black MAT.png
   Black MAT.pz2
   Blonde MAT.png
   Blonde MAT.pz2
   Brown MAT.png
   Brown MAT.pz2
   Red MAT.png
   Red MAT.pz2
   White MAT.png
   White MAT.pz2



Application Instructions:


1. Start Poser or DAZ Studio and load M4, H4 or F4 into the scene. Turn off IK and zero the figure.

2. Open the Character library and then BeardM4.

3. Load the beard figure and conform it to the figure you are using.

4. Select the whole body of the beard figure and take a look at the morph dials that are available in the dials menu. NOTE: If you are using the beard with H4 select the head part and set the Hiro Fix dial to 1.000

5. Use the morph dials for fitting to the character you are using.

6. To change the colour of the hair open the Pose library and then BeardM4.

7. Load one of the poses to change the colour.

8. You can also easily change the colour of the beard in the material room or surface select menu by changing the diffuse colour of the beard material zone. See your handbook for instructions on how to do this. In this way you can select any possible colour for the hair that you want.



I hope you enjoy using the beard! 

If you have any questions just send an email to the address above.


Cheers

Adam

You may use this package as you wish in your commercial and non-commercial renders. You are not permitted to redistribute the package or any of its contents without written permission.